SAP Center

Technician Entrance

On non-show days, park in parking lot. On most show days, no parking will be allowed in the parking lot until load out. There is limited spaces available on adjacent streets or you may park at Almaden Financial Plaza Garage if you have a parking pass. Parking passes are available at Security.

Enter through employee entrance on W. St John. Meet in bowl for load in, by loading dock for load out.

Dress Code

Work Cloths for Set up and Strike

Show Blacks for Deck Call

All clothes should be clean, no tears or stains; shirts should be buttoned up, pants pulled up; no open toed shoes.   Work Clothes: Jeans or other work pants; shorts or sleeveless shirts may not be acceptable in certain circumstances.   Show Blacks: Same as work clothes but black; jeans or cargo pants, small logos are acceptable.   Tech Blacks: Collared shirt (polo or button up), small logos may be acceptable; unfaded black jeans or Dockers; black shoes or sneakers.   Dress Blacks: Button up black shirt, no logos; black dockers or dress slacks, polishable shoes.   PPE:   Hard hats: Ansi Z89.1 compliant. Chin straps required for all climbers   High Vis: Class 2 or 3  

Recommended Tools

Riggers
Full Body Harness ANSI Z359
Y Lanyard ANSI Z359
120’ Rope 5/8” Single or Double Braid
Sheave
Multi Loop
Carabineers
Plumb Laser
Fall Arrest Slings
Klein Tool
 
Stagehands
Flashlight
4 in 1 Screwdriver
Crescent Wrench
Multi-tool
Gloves

 

From the Outline of Workers Obligations   A WORKER AT THE JOB SITE SHALL HAVE THE REQUIRED TOOLS A Basic Hand Tools required: Hammer, 8” Adjustable Wrench, Slotted & Phillips Screwdriver, Pliers, Wire Cutters, Knife, and Gloves, Pen or Pencil and Flashlight. Other specific tools may be required for other specifically assigned work (i.e., riggers, A/V techs, etc.) If this is the case, the appropriate steward will notify you. Steel toe safety shoes and safety glasses (if you normally wear glasses are strongly recommended and are the responsibility of the worker. Recommended Tools include: Tool Belt or Pouch, Battery Powered Screwdriver/Drill, Measuring Tape, Socket, Open End, Box End and/or Ratchet Wrenches. Failure to have the required tools may result in your replacement on the call.