San Jose Convention Center

San Jose McEnery Convention Center

Technician Entrance

Enter the SJCC through the Employee Entrance off of Viola Street which is located at the rear of the venue.

Dress Code

No logos except IATSE or shirts provided by client with a logo
Tech Blacks for set up and strike
Dress Blacks for Event Day
Hard Hats during overhead work

All clothes should be clean, no tears or stains; shirts should be buttoned up, pants pulled up; no open toed shoes.   Work Clothes: Jeans or other work pants; shorts or sleeveless shirts may not be acceptable in certain circumstances.   Show Blacks: Same as work clothes but black; jeans or cargo pants, small logos are acceptable.   Tech Blacks: Collared shirt (polo or button up), small logos may be acceptable; unfaded black jeans or Dockers; black shoes or sneakers.   Dress Blacks: Button up black shirt, no logos; black dockers or dress slacks, polishable shoes.   PPE:   Hard hats: Ansi Z89.1 compliant. Chin straps required for all climbers   High Vis: Class 2 or 3  

Recommended Tools

Riggers
50’ Rope 5/8” Single or Double Braid
Sheave
Multi Loop
Carabineers
Plumb Laser
Disto w/ Monopod
Full Body Harness ANSI Z359
Single or Y Lanyard ANSI Z359
Eye Protection

Carpenter
Tool Belt
Tape Measure
Hammer
4 in 1 Screwdriver
Screw Gun, Extra Battery, Charger and Phillips Bit
Crescent Wrench
Ratchet Wrench - 3/8" drive, 3/8", 7/16", 1/2", 9/16" deep sockets
Channel Locks
Pliers
Vise Grips
Wire Cutters
Allen Set
Matt Knife
Flashlight
Safety Glasses
Gloves
Pen and Pencil
Black Sharpie

Electrician
Tape Measure
4 in 1 Screwdriver
Crescent Wrench
Ratchet Wrench - 3/8" drive, 3/8", 7/16", 1/2", 9/16" deep sockets
Channel Locks
Pliers
Wire Cutters
Allen Set
Pocket Knife
Flashlight
Safety Glasses
Gloves
Pen and Pencil
Black Sharpie

Audio and Video Assist
Flashlight
4 in 1 Screwdriver
Crescent Wrench
Multi-tool
Jewelers Screw Drivers - (Philips and Flat)
Needle Nose Pliers
Assorted Nut Drivers
Pocket Knife
Circuit Tester
Board Tape or Masking tape
Electrical Tape
Black Sharpie
Gloves
Pen and Small Pad of Paper

From the Outline of Workers Obligations   A WORKER AT THE JOB SITE SHALL HAVE THE REQUIRED TOOLS A Basic Hand Tools required: Hammer, 8” Adjustable Wrench, Slotted & Phillips Screwdriver, Pliers, Wire Cutters, Knife, and Gloves, Pen or Pencil and Flashlight. Other specific tools may be required for other specifically assigned work (i.e., riggers, A/V techs, etc.) If this is the case, the appropriate steward will notify you. Steel toe safety shoes and safety glasses (if you normally wear glasses are strongly recommended and are the responsibility of the worker. Recommended Tools include: Tool Belt or Pouch, Battery Powered Screwdriver/Drill, Measuring Tape, Socket, Open End, Box End and/or Ratchet Wrenches. Failure to have the required tools may result in your replacement on the call.